Proximity Switch and Contactless Sensor, control any light source

The WDN-04 proximity switch is used to switch on or switch off the light without touching. The switch is activated by placing a hand close to the surface under which the sensor is mounted. This method of control does not require direct contact with the sensor, which can be built-in or invisible for the user. The aesthetics of WDN-04 control recommends its use in kitchen and bathroom furniture.

Nominal supply voltage: 230 V AC
Nominal power consumption: 0,25 W – stand-by; 0,9 W – with operating output
Number of channels: 1 x voltage output 230 V AC
Relay contact parameters: 5 A for 250 V AC (1250 VA)
Output circuit nominal load: 300 W
Hand proximity detection from a distance of 10 to 40 mm
Sensor’s cable length and diameter: 2,5 m / 4 mm
Sensor’s dimensions: Diameter 35 mm, Thickness 11,5 mm
Sensor’s connection: Jack plug 3,5 mm
Number of terminal clamps: 4
Section of connecting cables: Up to 2,5 mm2
Ambient temperature range: -10 ÷ +55 o C
Operating position: free
Switch mounting: Surface – a possibility to screw to the mounting surface
Casing protection degree: IP20
Protection level: II
Dimensions: 41,5 x 95 x 27,5 mm
Weight: 50 g
Reference standard: EN 60669; EN 61000

The switch is dedicated to controlling traditional (conventional light bulbs, halogens, LED lamps) and low-voltage (12 V AC halogens, LED diodes) light sources. 
In order to control the low-voltage sources, it is necessary to connect an appropriate power supply or transformer system to the switch output. 

The sensor can be mounted in wood, glass, stone and other materials excluding the ones with metal (max. 10mm distance from the top).
The switch has small dimensions and is designed for surface mounting with a possibility to be screwed to it. WDN-04 meets the required safety standards and can also be installed on flammable materials, e.g. wood, furniture boards, and plasterboard.